When not used for long periods, the batteries should be disconnected inside the decoy to prevent full discharging, because if the battery pack voltage falls below 1.5 V, the charger IC board will not permit charging. However, here are some steps to “resuscitate” a dead battery pack. Warning: you will need a 12 V power supply with alligator clips … Read More
Protected: How to assemble a TadPro
There is no excerpt because this is a protected post.
Protected: How to build a TadPro
There is no excerpt because this is a protected post.
Protected: external iPhone 3.5 stereo mini connection
There is no excerpt because this is a protected post.
Protected: TadPro formatting tips
There is no excerpt because this is a protected post.
Inputing external audio into TadPro, part 1
Attempt to add a 0.25 V pk-pk 1 kHz signal into GoPro successful. Oscilliscope gets double the programmed signal amplitude-an effect of impedance mismatch, if I recall.
Protected: TadPro is working
There is no excerpt because this is a protected post.
Protected: Camera assembly with memory card SD reader extension
There is no excerpt because this is a protected post.
Protected: Camera assembled without external memory card and extra battery
There is no excerpt because this is a protected post.
- Page 1 of 2
- 1
- 2